PRODUCTS


SERVICES




SOLUTIONS




CONTACTS
COMPANY



CHOOSE YOUR COUNTRY
HOME APPLIANCE AND CARTON CLAMPS




USA

Home Appliance and Carton Clamps

Force-Matic

Force-Matic

The new Bolzoni Auramo Force-Matic generation 4, is an innovative, fully automatic mechanical, pressure control system designed specifically for clamp equipped forklifts.
Mainly is Force-Matic an effective system designed to prevent over clamping when handling paper rolls but can also be used with other clamps.

Range:

Plus:

  • Force-Matic optimizes clamping force with preset clamping factor by adjusting the clamping force according to the load weight.
  • The valve works basically as a mechanical calculator which continuously adjusts the clamping pressure as a function of load weight.
  • Installation and adjustments are quite straightforward and can be done using normal tools.
  • Effective pressure control device.
  • Prevent paper roll deformation by adjusting the clamping pressure according to the roll's weight.
  • Fully mechanical, no electrical connections required.
  • Fully enclosed.
  • Heavy duty aluminum construction.
  • Built around standard hydraulic components for easy service.
    Wide adjustability range to be used to most truck-clamp combinations.
  • Can be installed on Bolzoni Auramo clamps (Consult Bolzoni for information).
  • Easy installation.
  • Minimum maintenance.
  • Unique with Force-Matic is that it works with two separate hydraulic circuits.
  • Circuit 1 measures hydraulic force in lift mast cylinder and calculates roll weight.
  • Circuit 2 regulates clamping force automatically with input from circuit 1.
  • These two hydraulic circuits are connected mechanically with link shown in picture on the right.
  • This link can be adjusted to give the right balance between load weight and optimal clamping force.
  • With two separate hydraulic circuits Force-Matic will be able to have a wide operation range.
  • From low initial clamping force up to max required clamping force with high stability.
  • In addition this new system gives good speed of operation of the paper roll clamp.
  • Our goal is to have a clamp fitted with Force-Matic which shall be operator friendly and operate like standard clamp!